The APW5 is Bitmain’s most advanced PSU up to now and is compatible with both the 220V power supply and the 110V power supply that may be the usual in North The usa. It combines high efficiency and good dynamic performance into a power dense package. It also features overload, overheat, overcurrent and low voltage protection, making it well suited to 12V, ≤ 2600W* power devices (with 220v input).
DC Output Voltage: 12.25V
Rated Current (220V input): 216A
Rated Power (220V input): 2600W
Rated Current (110V input): 108A
Rated Power (110V input): 1300W
Ripple & Noise: Voltage Regulation: Source Regulation: Load Regulation: Setup, Upward thrust Time: Power off Protection Travel Time: >10mS
Interface Type: 7pairs of 6pin PCI-E connectors. 380mm length for every PCI-E cable.
Input Voltage Range: 90-265V AC
Input Current Range: 10.5-16.5A
Input Starting Voltage: 100-240V AC
Input Frequency Range: 47-63Hz
Power Factor: >0.95(full load)
Leakage Current: Low-voltage Input Protection: 90-100V AC
Output Short Circuit: Yes
Output Overcurrent (220V input): 216-255A
Output Overcurrent (110V input): 108-135A
Overheat Protection: Yes
Operating Temperature: -20 – +60℃
Operating Humidity: 20%-90% RH (non-condensing)
Cooling: Forced-air fan cooling
Fan speed: When the temperature of the heat sink is higher than 80 ℃, the fan runs at full speed.
Outputs 1300W – 2600W depending on 110v or 220v input voltage.
Has 7 pairs of 6-pin PCI-e connectors (14 total connectors). Images shown could also be inaccurate.
In a position to powering two AntMiner R4 miners when the use of 220v input.
Power cable not included. Uses standard PC power port (IEC-320-C13).