GOTD PCI-e Express 1X To 3 Port 1X Switch Multiplier HUB Riser Card +USB Cable 1PC

$42.99 (as of June 14, 2017, 3:08 am)

Buy product


2 layer PCB bard designing.
Compliant with PCI express 2.0, 1.1 Specification
1-slot PCI-E 1X to 3 slot 1X riser card with high speed USB 3.0 cable.
High spee USB 3.0 shield cable is flexible for 1U,2U,3U chassis.
Give a boost to 3 port high speed PCIe 1X card.
Solid capacitor provide extra stable power supply for PCI-e card
Mainboard size:(L*W*H)9.70*6.30*1.30cm/3.82″*2.48″*0.51″
PCI-E Card size:(L*W*H)11.90*6.60*1.90cm/4.69″*2.60″*0.75″
USB cable length:0.55m/1.8ft


Product installation instructions:
First, when you use the adapter card, the computer must be turned off before they may be able to plug the adapter card.
1. The first step, first of PCIe USB card plugged into the motherboard’s PCIe slot.
2. Use USB3.0 data cable adapter to connect the ends of the two USB port. Plug in the power supply.
3.The third step: After completion of the above two steps, first in no hurry to insert your PCI-E card, start the computer to see if your computer has been identified to the riser card, if you did not find the card, repeat the above operation 4. After completing the above three steps, turn off the computer, plug in your PCI-E card, to be careful not to insert the contrary,
5. then boot into the system, install PCI-E Card Driver

Package includes:
1 x Mainboard
1 × PCI card
1 × USB cable
If you want more than one PCI-E x1 slot on the motherboard was not any so much, it touches you’ll take into accounts it. It consists of two parts, one main card, interface installed via PCI-E X1 on the motherboard, two equipment cards, both of which are connected together via USB 3.0 cable.
The device card also uses the United States Pericom Pericom PI7C9X bridge chip, for switching PCI-E, PCI-E between.
But even USB 3.0, but also the theoretical bandwidth 5Gbps (625MB / s), one Into four Then remove the loss would only 150MB / s, and even PCI-E 1.x single-channel bandwidth also has
250MB / s, So this stuff more than enough to give you the best slots, there may not be enough bandwidth, not only for the performance requirements of the place. Due to this fact, the transferred PCI-E slot is the best version above 2.0, the 3.0 version is better.
Several Divided PCI-E 1X slot all is gen2 mode, although gen1 previously ,it may be ok

Additional information